Getting started
Setting up the device
WorkstationErgonomicDevice
When installing your device, please read the recommendations and safety
notes in the "Safety/regulations" manual.
We recommend that you place your device on a surface which is not slippery. In
view of the man y different finishes and varnishes used on furniture, it is possible
that the rubber feet w ill mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and no ises may
occur. To prevent this, a distance of at least 10 mm / 0.39" should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
A minimu m distance of 200 mm / 7.87" from the device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see "
Technical data", Page 55,
section "Ambient conditions"). Protect the device against dust, humidity and heat.
Connecting the machine to the mains
Mainsadapter,
2
1
► Connect the mains cable to the machine ( 1).
► Plug th
e mains plug into a three -pin socket (2).
After
the mains power cable has been attached, the device automatically switches
itsel
f on for a few seconds to run a system test, then switches off again.
14 Fujitsu
To Next Page
Loading...
