Troubleshooting and tips
Troubleshooting and tips
Refer to the safety notes in the "Safety/regulations" manual and in th e "Getting
started", Page 13 chapter when connecting or disconnecting cables.
If a fault oc c u rs, try to c
orrect it as described in the following documentation:
• in this chapter
• in the documentation for the connected devices
• in the help systems of th
esoftwareused
• in the documentation for your operating system
Help if problems occur
Should you encount
er a problem with your compu ter that you cannot resolve yourself:
► Note the ID number
of your device. The ID number is found on the type rating
plate on the back,
the underside or the top of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "
http://support.ts.fujitsu.com/con tact/servicedesk"). When
you do this, please have ready the identity number and serial number of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on y our device
Cause
Troubleshooting
The mains voltage supply is faulty. ► Check whether the power cable is plugged
properly into the device and a grounded
mains outlet.
Internal power supply overloaded.
► Pull the power plug of the device out of the
mains outlet.
► Wait app
rox. 3 min.
► Plug the power plug into a properly grounded
mains outlet again.
► Switc
h the device on.
28 Fujitsu
To Next Page
Loading...
