System expansions
► Press on the retaining clip until it you feel it engage (2).
► Close the casing (see "
Closing the casing" , Page 35).
If you have installed o r removed a PCI board, please check the relevant PCI
slot settings in the BIOS Setup. If necessary, cha nge the settings. Further
information is provided in the PCI board documentation.
Replacing the processor
► Open the casing (see " Opening the casing", Page 34).
► Remove the heat sink (see "
Removing the he at sink", Page 52).
► Replace the processor as described in the m anua l for the mainboard.
► Install the heat sink again (se e "
Installing the heat sink", Page 52).
► Close the casing (see "
Closing the casing" , Page 35).
Installing an d rem
oving processor cooling devices
Removing the heat sink
The shape and position of the heat sink are device-dependent.
► Open the casing (see "
Opening the casing", Page 34).
► Undo the screws on the heat sink.
► Lift the heat sink out of the casing.
You c an now replace the processor.
Installing t
he heat sink
► Open the casing (see " Opening the casing", Page 34).
► Reinstall
theheatsinksothattheairflow is fed towards the back of the
casing (se
e arrow on the heat sink).
► Tighten the screws.
Never attach or detach fans during operation. This can cause problems
controlling the mainboard fan.
52 Fujitsu
To Next Page
Loading...
