Getting started
Connecting the keyboard
You can connect a USB keyboard or a PS/2 keyboard to your device .
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Inser t the flat rectangular USB plug of the keyboard cable into one of the device’s USB ports.
USBport
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
ConnectingaP S /2keybo
ard
Connecting,
The P S/2 keyboard is only detected b y the d evice if you connect the keyboa rd
when the device is switched off and then switch the device on again.
► Switch your device off.
► Plug the round plug of the keyboard cable into the keyboard port on the device.
Keyboard,
► Switch your device on again.
Connecting external devices to the parallel
(optional) or seri
al port
ParallelportSerialportParallelportSerialportExternaldevicesDevices
External devices can be conn ecte d to the parallel or serial port (e.g. a printer or a scanner).
► Connect the data cable to the external device.
► Depending on th
e device, connect the data cable to the parallel port or the serial port.
For an exact des
cription of how to connect exte rnal devices to the corresponding
port, please r
efer to the documentation of the external device.
Port settings
ParallelportSerialport,
You can change the port settings (e.g. address, interrupt ) in the BIOS Setup.
Device drivers
Devicedrive rsDevice drivers,
The devices connected to the parallel or serial port require drivers. Your operating
system already includes many drivers. If the required drive is missing, install it. Current
drivers are usually available on the Internet or will be supplied on a data carrier.
18 Fujitsu
To Next Page
Loading...
