System expansions
Removing the module holder with SmartCard reader
and/or WLAN module
► Open the casing (see " Opening the casing", Page 34).
► Disconnect the cables connec
ted to the modu le holder.
1
1
2
► Remove the screws (1).
► Push the module holder out of the casing in the direction of the arrow (2).
► Remove the SmartCard reader and WLAN module from the mo dule holder (see "
Removing
the SmartCard reader from the module holder", Page 43 and "Removing the WLAN module
from the m odule holder", Page 43) an d install the module holder again ( corresponds to
"
Installing the module holder with SmartCard reader and/or WLAN module", Page 41).
or
► Remove the SmartCard re ader and WLAN mo dule from the module holder (see "
Removing
the SmartCard reader from the module holder", Page 43 and "Removing the WLAN module
from th e module holder", Page 43) and install a blind cover in the drive bay.
► Close the casing (see "
Closing the casing" , Page 35).
42 Fujitsu
To Next Page
Loading...
