Fujitsu DL3100 User Manual

FUJITSU DL3100
User’s Manual 8-5
Problem Solution
An ejection error occurs even
after the paper has been
completely ejected.
Or, printing continues even after
the paper has run out.

It is conceivable that the paper
sensor is malfunctioning. In this
case, carry out the following
corrective action.
1) It is conceivable that the sensor is
malfunctioning due to the effect
of external light. In this case,
change [Intrusion light mode] of
Setup to [Yes].
2) When using single paper, set
[Single Form Length] to match
the size of the paper used.
3) Press the [Load / Eject] switch
when suction operation is not
performed even if the single paper
is set.
While printing on continuous
paper is taking place, the paper
separates from the tractor, or an
error occurs in the paper feed
operation.

When setting the paper on the
tractor, be careful not to apply an
excessively high tension in the
width direction of the paper.
When single paper is drawn in,
the corners of the paper may
become creased, or the paper may
be drawn in obliquely.

If the paper guide is at the rightmost
end position, shift it slightly toward
the left side before use.

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English