Fujitsu DL3100 User Manual

FUJITSU DL3100
User’s Manual xiii
CAUTION
The print head and internal frames become extremely hot during printer operation and remain so
immediately afterwards. Do not touch these parts until sufficient time has passed to allow them to
cool.
Otherwise, burns or personal injury may result.
Do not touch the paper feed- or ejection openings while the printer is operating.
Otherwise, personal injury may be result.
Do not touch the printer cable connectors or the metal part of the print head.
Otherwise, personal injury or a printer failure may result.
Do not touch the print head while it is moving.
Otherwise, burns or personal injury may result.
Note that continuous forms that are fed in the reverse direction continuously may come off the
paper feed tractors.
Operate the printer with the paper thickness set to the appropriate paper thickness.
Use only an original ribbon cassette that is specified as suitable by Fujitsu.
Textile fibers accumulate on components inside the printer and parts of the roller, so clean these
parts regularly.
Do not turn the ribbon feed knob in the reverse direction.
Otherwise, the ribbon may become jammed and stuck.
If printing is started with a slack ribbon, the ribbon may become tangled or the ribbon feed
mechanism may become locked.
The print head is extremely hot immediately after printing. When replacing the ribbon, verify that
the print head is sufficiently cool before setting the print head to the ribbon replacement position.

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English