Fujitsu DL3100 - Page 157

FUJITSU DL3100
User’s Manual C-17
Function
Command
Set bottom margin
ESC N (n)
Sets the bottom margin on continuous paper to n lines
(in the current line spacing) from the top-of-form
position on the next page.
(0 < n ≤ 127, 0 < (current line spacing) × n < (page
length))
Cancel bottom margin
ESC O
Set right margin
ESC Q (n)
Sets the right margin to n columns in the current
character pitch, as measured from the left most printable
column
(1 ≤ n ≤ 255)
(left margin) < (current pitch) × n ≤ (printable area
width)
Set left margin
ESC l (n)
Sets the left margin to n columns in the current character
pitch, as measured from the left most printable column
(1 ≤ n ≤ 255)
0 ≤ (left margin) <(right margin)
Control-code character printing
ESC ( ^ (nL)
(nH) (d1 . . .
dk)
Print data as characters
• Prints data bytes d1 through dk as characters, not
control codes
• The amount of data to be sent is calculated as follows:
k = ((nH × 256) + nL)
(0 ≤ nH ≤ 127, 0 ≤ nL ≤ 255)
Enable printing of upper control codes
ESC 6
Tells the printer to treat codes from 128 to 159 as
printable characters instead of control codes
Enable upper control codes
ESC 7
Tells the printer to treat codes from 128 to 159 as control
codes instead of printable characters