Fujitsu DL3100 - Page 184

FUJITSU DL3100
C-44 User’s Manual
Function
Command
Stops printing.
After printing, this command activates the buzzer and
disables printing.
ESC j
Set n/216" or n/180" line spacing
This command sets the line spacing to n/216". All
subsequent line feed operations will move the print
position n/216" down the page.if AGM mode is setting
to Yes,this command sets the line spacing to n/180".
n must be in the range 1 to 255.
ESC 3 (n)
Set n/72" or n/60" line spacing
This command allows you to select a line spacing of
n/72". Your selection does not take effect until
you activate it with the Esc 2 command.
if AGM mode is setting to Yes,this command sets the
line spacing to n/60".
n must be in the range 1 to 85.
Notes
If n is outside the range 1 to 85 the default line
spacing, 1/6" is selected.
ESC A (n)
Move Paper Vertically
Advances the paper in a vertical movement a distance
of n/216 inches relative to the current print position.
if AGM mode is setting to Yes,advances the paper in a
vertical movement a distance of n/180 inches.
n is a value from 0 to 255 (decimal) or 0 to FF (hex).
Notes
The existing line space setting is not affected.
ESC J (n)