PC Specialist's Handbook ErgoPro e-, x- and s- Series
First Edition, Release 4 - June 1998 Page 27
The time on the battery-powered system clock is displayed in the top right corner of the screen. To set the time,
e.g., in the case of Daylight Savings Time:
1.
Move to the Set time parameter by using the UP and DOWN ARROW keys and press ENTER.
2.
Type the correct time in the entry window in the format Hours: Minutes: Seconds. SETUP uses a 24-hour
clock, i.e., 6 a.m. is expressed as 6:00, 6 p.m. as 18:00.
You may use any non-numeric character or a space to separate the hours, minutes and seconds, but the
separator is always displayed as a colon (:).
If you do not enter a figure for the seconds, 00 will be used.
3.
Press ENTER to save the time, and the calendar is updated immediately.
4.
To exit without setting the time, press ESC.
If you enter the time in an incorrect format, a short beep sounds, and the time does not change.
Start-up NumLock
This parameter determines whether the numeric keypad is in numeric mode when you start the system. Set the
parameter to Enabled or Disabled according to the way your operating system works; some operating systems
automatically use the numeric mode when loaded.
To Next Page
Loading...
Need help?
General