Fujitsu ErgoPro e Series - Sequences of Five Beeps

ErgoPro e-, x- and s- Series PC Specialist's Handbook
Page 56 First Edition, Release 4 - June 1998
Sequences of five beeps
If you hear a sequence of five beeps immediately after you have started the system, or when updating the BIOS,
BIOS has detected an FLASH RAM or a LDB-file failure.
The following list contains the signal sequences. Short beeps are indicated with •, long beeps with -. Message
numbers are shown in brackets.
• • • • • Error reading diskette
• • • •
-
Cannot read diskette (or no diskette in the drive)
• • •
-
• Cannot find the BIOS file
• •
-
• • FLASH RAM failed
• •
-
•
-
FLASH RAM erase failed
• •
- -
• FLASH RAM programming failure
• •
- - -
Bad file