ErgoPro e-, x- and s- Series PC Specialist's Handbook
Page 32 First Edition, Release 4 - June 1998
The Admin-Config menu with its default parameter values is shown below.
Floppy drive 0, Floppy drive 1
This parameter describes the type of diskette drive(s) installed in the system unit. In SETUP the first diskette
drive (drive A) is defined as Floppy drive 0 and the second (drive B) as Floppy drive 1.
Select the correct value by following these guidelines and press ENTER to save your selection.
In standard configurations diskette drive A is a 3.5-inch, 1.44 MB drive. Thus, the correct value for Floppy drive 0
is 3.5" 1.44 MB.
If your system unit has no second diskette drive (drive B), the correct value for Floppy drive 1 is None.
If you install an optional device such as a tape streamer unit in drive B, use the value None for Floppy drive 1.
To Next Page
Loading...
