ErgoPro e-, x- and s- Series PC Specialist's Handbook
Page 34 First Edition, Release 4 - June 1998
Set the DMA channel for the parallel port. By default, the DMA channel is set to Disabled. Select Disabled
only if you select ECP for the next parameter, Mode.
Mode
Determine the way in which the parallel port is to be used. The available values are: SPP (Standard
Parallel Port, which is used by AT- and PS/2-compatible peripherals), EPP (Enhanced Parallel Port, which
is used by peripherals supporting EPP), ECP (Extended Capabilities Port, which is used by peripherals
supporting ECP)
Serial port 1 and serial port 2
This parameter controls the address of the serial ports on the system board. Press ENTER on either parameter
to view an entry window with the following available selections.
Auto
A port determination scheme is used; the system checks at power-on if any additional expansion boards
with serial ports are connected. If one additional port is connected, the system board Serial port 1 is
configured for 0378H or 0278H, which ever address is not in use, and the system board Serial port 2 is
disabled. If two additional ports are connected, the system board serial ports are automatically disabled.
To Next Page
Loading...
Need help?
General