ErgoPro e-, x- and s- Series PC Specialist's Handbook
Page 36 First Edition, Release 4 - June 1998
The file name for the BIOS load file is BXX_VVV.LDB where XX is BIOS ID and VVV is the revision identifier.
Two reload options are available and are explained in the table below.
BIOS modules
Load only the BIOS modules into FLASH RAM.
BIOS and Loader
Reload the BIOS and the boot-block portion of the flash memory. This option is reserved primarily for ICL
service personnel.
To load a new BIOS:
1.
Press ENTER on the parameter BIOS reload and select BIOS modules.
2.
Insert the diskette with the BIOS load file into drive A.
3.
Press ESC and exit SETUP with the option Update parameter memory and exit.
4.
Wait for approximately one minute for the BIOS to load. During this time the screen is blank. The system
reboots automatically, and the power-on self-test is performed as indicated by a series of beeps which are
outlined in the section Power-on test and start-up messages.
If a BIOS is found to be invalid, you are alerted by a special beep sequence (explained below). In this case, you
must reload your BIOS as described in the steps above.
To Next Page
Loading...
Need help?
General