PC Specialist's Handbook ErgoPro e-, x- and s- Series
First Edition, Release 4 - June 1998 Page 39
Use this parameter if your system unit is functioning as a server or working as a multi-user computer. Press
ENTER on the parameter to toggle between the values Enabled and Disabled; their effects are explained below.
This function is available only in DOS environment (special driver needed).
Enabled
The system boots, but it does not prompt for a password. Instead, the keyboard and mouse lock. In this
state, users cannot access the system with the keyboard or mouse until the User password is given. In
case of a PC unit with Instant on function, system also boots up after power break down.
Disabled
The system prompts for the User password at boot up. In case of a PC unit with Instant on function,
system does not boot up after power break down.
Use of this parameter requires the installation of a unique device driver in order for the parameter to function as
explained above. Contact your ICL service representative for more information.
Anti-theft system
Use this parameter to activate the Theft Prevention system. If the power to the computer is disrupted, then the
System password is requested before the User password in order to start the computer. Options are:
Enabled
Disabled
User password unlocks
Use this parameter to unlock the activated Theft Prevention system with the User password instead of the
System password. Options are:
Enabled
Disabled
To Next Page
Loading...
Need help?
General