Important notes
Safety notes for the system
This device complies with the relevant safety regulations for data processing equipment,
including electronic office machines for use in an office environmen t. If you have
any questions about whether the device c an be used in the intended environment,
please contact your sales office or our Service Desk.
• The display surface of the device is sensitive to pressure and scratches. You should therefore
be careful with the display surface in order to avoid lasting damage (scratches).
• If the device is brought into the installation site from a cold environment, condensation
can form. Before operating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing and operating the device, please observe the notes on ambient
conditions in "
Technical dat a", Page 59 and the instructions in "Setting up
an ergonomic video workstation", Page 15.
• To ensure sufficient ventilation, the air inlet and outlet openings of t he device must be kept clear.
• The device automatically sets itse lf to the correct voltage within the range from 100 V to 240 V.
Make sure that th e local mains voltage is neither higher nor lower than this range.
• Ensure that the power socket on the device and the mains outlet are freely accessible.
• The on/off switch does not disconnect the device from the mains voltage. To completely
disconnect from the mains voltage, you m ust remove the mains plug from the mains socket.
• The device is equipped with a power cable that complies with safety standards.
• Use the supplied power cable only.
• Lay the cables in such a way that they do not create a hazard (danger of tripping)
and cannot be damaged. When connecting the de vice, observe the relevant notes
in chapter "
Connecting external devices", P age 24.
• No data transfer cables should be connected or disconnected during a thunderstorm.
• Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get
inside the device (danger of electric sho ck, short circuit).
• The device is not waterproof! Never immerse the device in water and protect
it from spray water (rain, sea water).
• In an emergency (e.g. damaged casing, o peration controls or cables, penetration
of liquids or foreign matter), switch off the device, disconnect the power plug
and contact your sales out let or our Service De sk.
• Only s et the resolution and refresh rates that are indicated in chapter "
Technical
data", Page 59. If you set other values, you may damage the device. If you are
in any doubt, contact your sales outlet or our Service Desk.
• Use a screen saver with moving images and activate the power management for
your monitor to prevent still images from "burning in".
• We recommend that you place your de vice on a durable, non-slip surfa ce. In view
of the many different finishes and varn ishes used on furn iture, it is p ossible that the
feet of the device m ay mark the surface they stand on.
12 Fujitsu
To Next Page
Loading...
