Getting started
Getting started
Gettingstarted
Please observe the safety information in the "Important notes", Page 11 chapter.
Unpacking and checking the delivery
The display surface of the device is sensitive to pressure and scra tches.
Always hold the device by the casing!
It is recommended not to throw away the original packaging material! It may be
required for reshipment at some later dat e.
PackagingContentsofd eliver
y
Packaging,
► Unpack all the individual parts.
► Check th e contents of the package for any visible damage caused during transport.
► Check whether the delivery conforms to the details in the delivery note.
► Should you discover that the delivery does not correspond to the delivery
note, notify your local sales outlet immediately.
Steps for initial setup
Preparingforfi rstuse, overviewPreparingforu se,
Only a few steps are necessary to put your new device i nto operation for the first time:
• Select a location for device and set up device
• Connecting external devices such as a mouse and keyb oard
• Check the voltage at the m ains outlet and connect the device to an electrical outlet
• Switch the device on
You will learn more about the individual steps in the following sections.
External devices
If you have received other external devices in addition to your own device (e.g.
a printer), do not connect the se until after the initial insta llation. The following
sections describe how to connect these external devices.
Drives and b oard s
If you have received drives or boards with your device, please do not install
them until aft e r first-time setup. How to install drives and boards is described
in the "
System expansions", Page 48 chapter.
14 Fujitsu
To Next Page
Loading...
