Fujitsu ETERNUS AB Series - Power Canister Replacement Procedure (60-drive)

1. ETERNUS AB/HB Installation
Installation Area
Site Planning Guide
34
Installation Area
This section explains the installation areas and the service areas that are required for an ETERNUS
AB/HB that is installed in a Fujitsu 19-inch rack.
Secure service areas in the front and rear of the 19-inch rack.
Figure 14 Installation Area and Service Area (When the Lifter Is Not Used)
*1: The areas on the left and right of the front service area are not required if the ETERNUS AB/HB is installed
in the rack.
Rear
service area
Front
service area
850 mm or more
1,016 mm or more
19-inch rack
560 mm or more (*1) 560 mm or more (*1)
To p