Fujitsu ETERNUS AB Series - Fan Canister Replacement Procedure (60-drive)

1. ETERNUS AB/HB Installation
Installation Environment
Site Planning Guide
37
Installation Methods
• Perform one of the following rack installation methods to ensure the safe use of an ETERNUS AB/
HB that is installed in a rack:
- To secure a rack, use a rack without stabilizers and secure it to the building with the leveling
feet.
- If a rack is not to be secured, make sure to use a rack with stabilizers and use these stabilizers
to prevent the rack from toppling over.
• The installation method that should be used depends on the installation location, the floor
conditions, and the type of racks where the ETERNUS AB/HB is to be installed. Contact your
installation contractor for more details regarding installation and how the installation should
actually be performed.
An installation diagram when installing a rack (or the floor dimensions of the rack) is shown below.
Figure 16 Floor Dimensions of the Rack (of 19-inch Racks)
919 mm (leveling feet)
733 mm (caster)
Front Rear
523 mm (caster)
350 mm
570 mm (leveling feet)
175 mm
700 mm
1,050 mm
1,013 mm
95 mm
826 mm
65 mm
89 mm
47 mm
140 mm
Caster
Leveling feet
Cable slot