Fujitsu ETERNUS AF S3 Series - Page 20

■
When Controlling by the Power Switch
1 Press and hold the Power switch of the controller enclosure for four seconds or more.
ETERNUS AF150 S3/AF250 S3 ETERNUS AF650 S3
Contr
oller enclosure
Power switch
Power switch
The READY LED on the controller enclosure is turned off.
IMPORTANT
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the
ETERNUS AF power may turn on.
2 The power of the
ETERNUS AF is disconnected.
When the power is disconnected, the POWER LED of each enclosure is turned off.
■
When a Power Synchronized Unit Is Used
If the server is turned off, the ETERNUS AF is also turned off.
1. Basic Operation
Powering On and Off
20 Operation Guide (Basic)