Fujitsu ETERNUS AF S3 Series - Component Names; Controller Enclosure; Front; Figure 8 Front View of a 2.5 Type Controller Enclosure (ETERNUS AF150 S3;AF250 S3)

A. Component Names
This appendix provides the component names of the ETERNUS AF.
Controller Enclosure
An operation panel and drives are installed in the front of the ETERNUS AF controller enclosure. Controllers and
power supply units are installed in the rear.
Front
This section provides the names of the components in the front of a controller enclosure.
■
ETERNUS AF150 S3/AF250 S3
Figure 8 Front View of a 2.5" Type Controller Enclosure (ETERNUS AF150 S3/AF250 S3)
Slot#0 Slot#1 Slot#2 Slot#3 Slot#4 Slot#5 Slot#6 Slot#7 Slot#8 Slot#9
Slot#10 Slot#11 Slot#12 Slot#13 Slot#14 Slot#15 Slot#16 Slot#17 Slot#18 Slot#19 Slot#20 Slot#21 Slot#22 Slot#23
1
3 3
2
1 Operation panel (refer to "
■ Operation Panel" (page 71))
2 2.5" drive (refer to "■ Drives" (page 73))
3 Flange cover
67 Operation Guide (Basic)