Controller enclosure
Drive enclosure 1
Drive enclosure 2
(drive enclosure
that is to be added)
Controller 1
Remove from
here
Remove from
her
e
12 Click the [Next >>] button.
The [Connect Cable] screen appears.
13 Connect the DI (OUT) port of CM#1 in the controller enclosure to the DI (IN) port of IOM#1 in the drive
enclosure that is to be added with a mini SAS HD cable between enclosures.
The following figure shows how a mini SAS HD cable between enclosures (CE and DE) is connected when
drive enclosure 2 is added.
The FAULT LED for the DI (IN) port to which the cable is to be connected and the LINK/FAULT LED for the
DI (OUT) port blink on and off.
4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
45 Operation Guide (Basic)
To Next Page
Loading...
