Fujitsu ETERNUS AF250 S2 - Storage System Monitoring; Checking LED Status; ETERNUS Web GUI Status Display

3. Storage System Monitoring
This chapter describes the status monitoring of the ETERNUS AF.
Checking LED Status
The status of the ETERNUS AF can be checked by the LEDs.
If the FAULT LED in the operation panel is amber, contact your maintenance engineer.
Displaying Status via ETERNUS Web GUI
The status of the ETERNUS AF and the usage status of RAID groups, TPPs, and SDPs can be checked in the Over-
view screen of ETERNUS Web GUI.
Figure 39 ETERNUS Web GUI Screen
Table 11 shows the general status.
Status of the ETERNUS AF is monitored periodically, and the result is displayed as a general status icon with
character strings.
Table 11 General Status of ETERNUS Web GUI
Status Description
(green)
The ETERNUS AF is in a normal state.
(red)
An abnormality is detected at a power-off, and I/O access from the server
cannot be received.
(red)
The ETERNUS AF is in error state.
41
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1842-06ENZ0