Fujitsu ETERNUS AF250 S2 - Additional Drive Enclosure Installation Procedure

■
About Shock
•
Do not handle the drive enclosure roughly or subject it to physical shocks when laying
it down.
•
Do not stack the drive enclosures.
•
Do not knock or drop the drive enclosure on hard objects.
Additional Drive Enclosure Installation Procedure
This section explains how to install additional drive enclosures in the ETERNUS AF.
•
If components are installed in a way other than as described in this section, damage
and/or device failure or electrical shock may occur.
•
Do not install the drive enclosure in the rack with cables, such as power cords, connec-
ted.
•
Do not knock the other devices installed in the rack when installing drive enclosures.
When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the tab
must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
Tab
5. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
53
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1842-06ENZ0