Fujitsu ETERNUS AF250 S2 - Component Names and LED Names; Controller Enclosures

1. Component Names and LED Names
This chapter provides the component names of the ETERNUS AF.
Controller Enclosures
An operation panel and drives are installed in the front of the controller enclosure. Controllers and power supply
units are installed in the rear.
Front
This section provides the names of the components on the front of a controller enclosure.
Figure 1 Front View of a Controller Enclosure
1
3 3
2
1. Operation panel
2. Drive
3. Flange cover
Rear
This section provides the names of the components on the rear of a controller enclosure.
Figure 2 Rear View of a Controller Enclosure
1
2
3 4
1. Controller (CM#0)
2. Controller (CM#1)
3. Power supply unit (PSU#0)
4. Power supply unit (PSU#1)
9
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1842-06ENZ0