Long Wave SFP+ Modules (16Gbit/s) Installation Procedure
This section describes how to replace a Short wave SFP+ module (16Gbit/s) in the host interface (FC 16Gbit/s)
with a Long wave SFP+ module (16Gbit/s).
•
If SFP+ modules are installed in a way other than as described here, damage and/or
device failure or electrical shock may occur.
1 Check that all components of the
ETERNUS AF are in normal status, using the [Storage System Status]
screen of ETERNUS Web GUI.
2 Check the port location of the Short wave SFP+ module (16Gbit/s) that is to be replaced by using the Inter-
nal Parts information in the [Channel Adapter Detail] screen.
Note that a Short wave SFP+ module (16Gbit/s) is displayed as "16G SFP+(MMF)" in the "SFP Type" field.
3 Turn off the ETERNUS AF.
Refer to "Powering Off" (page 37) for details on how to turn off the ETERNUS AF.
4 Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
5 Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module (16Gbit/s) that is to
be replaced.
Push the tab on the FC cable connector and pull out the cable.
Make sure to record the connecting port for the disconnected FC cable.
6 Remove the Short wave SFP+ module (16Gbit/s).
(1) Open the Short wave SFP+ module (16Gbit/s) lever upward.
(2) Pull the Short wave SFP+ module (16Gbit/s) straight out of the port cage.
Make sure to store the removed Short wave SFP+ module (16Gbit/s) with the fixing lever and the con-
nector cover attached.
5. Component Expansion/Function Enhancement
Installing Long Wave SFP+ Modules (16Gbit/s)
65
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1842-06ENZ0
To Next Page
Loading...
