Example:
#
# Copyright (c) 1992, by Sun Microsystems, Inc.
#
#ident "@(#)sd.conf 1.9 98/01/11 SMI"
name="sd" class="scsi" class_prop="atapi"
target=0 lun=0;
name="sd" class="scsi" class_prop="atapi"
target=1 lun=0;
name="sd" class="scsi" class_prop="atapi"
target=2 lun=0;
name="sd" class="scsi" class_prop="atapi"
target=3 lun=0;
name="sd" class="scsi"
target=4 lun=0;
name="sd" parent="lpfc" target=16 lun=0;
name="sd" parent="lpfc" target=16 lun=1;
# End lpfc auto-generated configuration -- do NOT alter or delete this line
•
Use the "lun=" format to list all the LUNs that are to be connected.
•
Set the "target=" value the same as the Loop-ID set in the [Set CA Parameters] window of ETERNUS Web
GUI or ETERNUSmgr.
The ETERNUS Web GUI or ETERNUSmgr Loop-ID is natively set as a hexadecimal value, which must be
converted to a decimal value for this setting.
● For switch connection
Add the descriptions of the logical units in the sd driver configuration file (sd.conf) using a text editor, such
as "vi".
•
Solaris 11 OS
If the "/etc/driver/drv/sd.conf” file does not exist, copy the "/kernel/drv/sd.conf" file to the "/etc/driver/drv"
directory and add the line to the newly copied "sd.conf" file.
If the "/etc/driver/drv/sd.conf” file exists, do not copy over the file but instead add the line to the existing
"sd.conf" file.
•
Solaris 10 OS
Add the line to the "/kernel/drv/sd.conf" file.
Do not delete the lun=0 description for the system disk target ID.
Chapter 2
Setup Procedure for Emulex Fibre Channel Cards
2.4 Setting Up the Server to Recognize the Logical Units
37
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0
To Next Page
Loading...
