Important notes
Important notes on p reparing your device for use
via the Power o ver Ethernet mo
dule
Using the Power over Ethernet module, you can operate the device via the LAN without an
additional power connection. You will need a suitable network infrastructu re for this.
To operate the device via the Power o ver Ethernet module, midspan devices conforming
to IEEE 802. 3at and shielded CAT 5 network cable or higher quality cable are required.
Endspan devices w ill only be supported in conjunction with a hardware c lassification.
Fujitsu recomm ends the use of the following midspan devices:
• 1 port midspan from Microsemi PD-9501G: S26361-F1744-L10
• 12 port midspan from Microsem i PD-9512G: S26361 -F1744-L20
Not all hardware configuration levels are possible while operating the device
via the Power over Ethernet module because of the limited power output. The
following hardware configurations are possible:
Internal memory expansion
according to Configurator
M.2 SATA module according to Con fig
urator
SmartCard reader internal SmartCard reader
Speaker
internal speaker
WLAN
internal WLAN mo
dule according to Configurator
PCI/PCIe cards or extra interfaces
none
Depending on the system utilisations, occupancy of external interfaces (excluding the keyboard,
screen, microphone and headset) may cause overloading of the Powe r over Ethernet module.
In order to support the largest possible occupancy of interfaces, if an overload occurs the
performance of the system is lowered by a reduc tion in the CPU frequency. If the CPU frequency
is permanently reduced, the occupan cy of the external interfaces must be checked a nd reduced
accordingly to prevent damage to the Power over Ethernet module or the midspan. Alternatively,
the system can also be connected via a suitable AC adapter (see note in this Operating
Manual). The system must be switched off before the AC adapter is connecte d.
If you are perhaps retrofitting the device with a Power over Ethernet modu le, please
pay attention to the maximum possible ex pan sion. If PCI/PCIe expansion cards are
installed, these must be removed, otherwise the Power over Ethernet module or the
midspan may be overloaded and switched off automatically.
Transporting the device
Device,Trans portati onRetransportation
Transport all parts separately in their original packaging or in a packag ing which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
12 Fujitsu
To Next Page
Loading...
