System expansio ns
Install and remove USB port
Depending on the configuration level of your de vice, there may be a location intended
for a USB port o n the rear panel of the device.
Install USB port
► Remove the casing cove r (see chapter "Opening th e c asing", Page 31).
2
1
3
► Put the USB port into position with the board side upwards on the inside
of the device at the flagged location (1).
► Secure
the U SB port using the 2 x M2.5 screws provided (3), max. torque 0,4 Nm.
► Connect the cable of the USB port to the connector on the mainboard (3).
► Refitt
he casing cover on the casing (see chapter "
Closing the casing", Page 52).
Fujitsu 37
To Next Page
Loading...
