Getting started
Horizontal operating position
If you wish to operate the device in the horizontal operating position, use
the two feet supplied for horizonta l operation.
Only mount the feet on the device side shown in the diagrams.
Proceed as follows to prepare the device for the horizontal operating position:
HorizontaloperatingpositionOperatingposition, horizontalBasefeet
► Disconnect the cables if required.
► Laythedeviceonitsright
side as shown, on a stable, flat and clean surface.
2
1
1
3
3
3
3
► Place the feet on the casing (1). In doing so, make sure that the 4 clips (2) on the
feet are aligned above the corresponding holes in the casing.
► To secure the fee t, press the clips in the direction of the arrow (2) until
they are felt to engage in the holes.
To protect your device against unauthorised removal of the feet, the feet
can also be secured with t wo screws each, of type M2.5x5 mm. These
are not included in the delivery scope.
► Secure the feet with the screws (3).
Fujitsu 17
To Next Page
Loading...
