Fujitsu FUTRO S940 - Removing the Power over Ethernet Module

System expansions
Removing the Power over Ethernet module
PoweroverEt hernetmodule,
► Open the casing (see "Opening the ca sing", Page 31).
1
2
1
► Undo the screw s (1).
► Pull the Power over Ethernet module in the direction of t he arrow (2) out
of the slot and lift it out of the casing.
► When required, reinstall the cross piece and the PCIe board (see "
Installing the board", Page 45).
► Close the casing (see "
Closing the ca sing", Page 52).
Ensure that cables are not trapped between the casing and the components.
44 Fujitsu