System expansio ns
Removing the board
Board,
► Open the casing (see "Opening the casing", Page 31).
1
2
► Loosen the screw (1).
► Remov e the board from the riser card (2).
You must reinstall th e rear slot cover plate for protection against fire and to
comply with th e Electromagnetic Compatibility (EMC) Directive).
► Reinstall the rear slot cover p late by inserting it in the installation slot from
the inside and securing it with the screw.
► Clo se the casing (see "
Closing the ca sing", Page 52).
Make sure that the c ables do not become trapped between the
casing and the components!
Fujitsu 47
To Next Page
Loading...
