System expansions
Do n ot throw away the rear slot cover plate. For cooling, protection
against fire and in order to comply with EMC regulations, you must refit
the cover plate if you remove the board.
4
2
3
1
► Insert the board into the riser c ard (1).
► Fix the board with the screw (2).
► Install the cross piece (3).
► Secure the cross piece with the screw (4).
► Close the casing (see "
Closing the ca sing", Page 52).
Make sure that the cables do not become trapped between the
casing and the compon ents!
46 Fujitsu
To Next Page
Loading...
