System expansions
Installing and removing a Power
over Ethernet
module (optional)
You can install an additional P
ower over Ethernet module in your device.
Before using the module for th
e first time, please obse rve the notes
in chapter "
Getting started
", Page 14.
If you are supplying the sy
stem with power via the PoE module, ensure that
no additional power su ppl
y (mains adapter) is c onne cted .
Installing the Power over Ethernet module
PoweroverEthernetmo
dule,
► Open the casing (see "Opening the ca sing", Page 31).
► If a PCIe board or p ower supply is installed, rem ove the cross piece and PCIe board or power
supply (see "
Removing the board", Page 47/"Remove power supply", Page 50).
1
2
► Break the cover (1) out of the casing.
► Place the Power over Ethernet module in the casing with the component side
facing upwards (2). Ensure that it engages in the slot.
42 Fujitsu
To Next Page
Loading...
