System expansions
Adding memory
MemorymoduleMainmemoryRemovingmemorySystemexpansionSystemexpansion
If you want to remove or add memory, proceed as follows:
Please observe the safety information in chapter "Important notes" , Page 11.
Use only memory expansions of type DDR4-2400.
Never use force when installing or removing a mem ory extension.
Make sure that foreign objects do not fall into the memory extension compartm ent.
Individual components ( e.g. the processor heat sink) can become very hot
during operation. We therefore recommend that you w ait one hour after
switching off the device b efore removing or insta lling the memory modules.
Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please
take no te of chapter "
Information about boards", Page 30.
Installing a memory
module
2
a
1
► Insert the memory module with the contacts
and the recess (a) facing the slot (1).
MemoryexpansionMemorymodule
► Carefully push the
memory module
downwards until yo
u feel it click
into place (2).
Removing memory modules
3
2
1
1
► Carefully push the two m ounting
clips outwards ( 1).
MemoryexpansionMemorymodule
The memory module snaps upwa rds (2).
► Pull the memory module ou t of its slot
in the direction of the arrow (3 ).
32 Fujitsu
To Next Page
Loading...
