Operation
Switching off the device
► Shut down the operating system in the proper w ay. In Windows: from the
Start menu select the Shut Down option.
Device,Monitor,
► If the operating system does not automatically switch the device into energy-saving mode or
switch it off, press the ON/OFF switch. Warning, this could lead to a loss of data!
If the device is switched off, it consumes a minimum of energy.
The ON/OFF switch does not disconnect the device from the mains voltage. To
completely disconnect the mains voltage, remove the power plug from the power socket.
► If necessary, switch the monitor off (s ee the operating manual for the monitor).
Activating power-saving mode
Due to custo mer requirements and requirements of the operating system, the
"Wake-on-LAN" (WoL) function is switched on by default. With the WoL function,
the power draw in O FF mode increases slightly.
To meet the req uirements of EC regulation 1275/2008 regarding the implementation of the
Ecodesign directive (2009/125/EC), the default WoL setting must be changed as follows:
► To start the BIO S Setup utility after the system start, press the ON/OFF
switch for two to three seconds.
or
► Press the
F2
function key or the
Del
key.
► In the Power sub-menu, change the External Power Button Control, LAN
and Keyboard settings to disabled.
► To save the setting and exit the BIOS Setup U tility, press function key
F4
.
After making this change, the system will achieve the lowest energy
saving mode during shut-down.
In this status, the “Wake-on-LAN” function can no longer be used.
Open BIOS Setup
BIOS-Se
tup
► When the system starts, press the ON/OFF switch for two to three s econds.
or
► Press (possibly several tim es) the
F2
key.
BIOS S
etup will be started. Select one of the tabs to access other setting options in BIOS Setup.
26 Fujitsu
To Next Page
Loading...
