Important notes
Cleaning the device
Device,Trans portati onRetransportationSystemunit, seeDevice
Turn off all power and equipment sw itches and disconne ct the power
plug from the mains outlet.
Do not clean any interior parts yo urself, leave this job to a s ervice technician.
Do not use any cleaning agents tha t contain abrasives or may corrode
plastic (alcohol, thinner or acetone).
Never clean the device with water! Water entering into the de vice could
present a serious risk to users (e.g. electric shock).
Ensure that no liquid enters the system.
Thesurfacecanbeclea
ned with a dry cloth. If particularly dirty, use a cloth that has been
moistened in mild dome
stic detergent and then carefully wrung out.
Use disinfectant wi
pes to clean the keyboard and the mouse.
Energy saving, disposal and recycling
DisposalEnergysavingRecy cling
You can find information on these subjects in chapter "Activating power-s aving mod e", Page 26,on
the Recovery DVD or on o ur website ("
http://www.fujitsu.com/fts/about/fts/environment-care/").
The following sections apply to t he FUJIT S U Thin Client FUTR O only:
Information about the "Eco-design directive": Regulation 1275/2008, based on the EU Eco-design
Directive (2009/125/EU), defines requireme nts for the power consump tion of electrical and
electronic do mest ic and office devices in stand-by and off mode.
In general, all FUTRO thin c lient products have been developed for energy-efficient operation and low
stand-by losses. Customer-specific requirements an d requiremen ts of the operating system, which
are a priority for optimal operation, can contradict the requirements of the above-mentioned regulation.
For administrative purposes, such as remote maintenance of systems, the "Wake-on-LAN"
(WoL) function is indispensable for our customers and is the refore a default setting. W hen the
WoL function is active, the maximum permissible p o wer draw can be exceeded slightly in OFF
mode. By deactivating the WoL function, it is possible to comply with the legal requirements.
Please see chapter "
Activating power-saving mod e", Pa ge 26 for the procedu re.
The energy saving mode (ACPI S4 Save-to-disk), w hich is familiar from many current mobile
and desktop systems, is not available in the embed ded operating systems for technical reasons.
Therefore, it is not possible to switch de vice s with this operating system autom atically into Off mode.
The operating system of a thin client is stored on a flash memory with optimised size and is provided
with write p r otec tion after configuration has been completed by the custo m er. This prevents data
security from being put at risk through frequent writing to a flash memory, such as when updating
the swapfiles in the operating system or through other applications. Every flash memory permits
only a limited number of write cycles. Both the activated write protection and the available limited
flash memory capacity rule ou t the possibility of activating e nergy saving mode (ACPI S4).
Fujitsu 13
To Next Page
Loading...
