RX300 S6 Options Guide 111
Further options
Ê Connect the front VGA cable to the system board. See cabling plan chapter
"Appendix" on page 125.
Ê Replace the fan box (see section "Installing a fan box" on page 117).
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 117.
9.3 TPM
Figure 91: TPM installation kit
Ê Open the server as described in section "Opening the server" on page 29.
Ê Remove the air duct as described in section "Removing the air duct" on
page 30.
Ê Remove the power supply cage as described in section "Removing the
power supply cage" on page 32.
1 TPM (Trusted Platform Module) 4 Special screw for TPM
2 TPM spacer (Server) 5 TPM screwdriver insert bit for
TPM special screw
3 TPM spacer (Server Blade)
/0123
To Next Page
Loading...
