Fujitsu PRIMERGY RX300 S6 - Installing USB Flash Module (UFM)

114 Options Guide RX300 S6
Further options
9.4 USB Flash Module (UFM)
Figure 95: UFM installation kit
Ê Open the server as described in section "Opening the server" on page 29.
Ê Remove the air duct as described in section "Removing the air duct" on
page 30.
Ê Remove the power supply cage as described in section "Removing the
power supply cage" on page 32.
1 USB Flash Module (UFM) 3 UFM spacer
2 UFM nylon screw
0
1
2