RX300 S6 Options Guide 91
Expansion cards and BBU
Figure 67: Installing a controller
Ê Install the expansion card into the PCI slot and press it carefully into the
associated plug-in location on the system board.
Ê Secure the slot cover with the screw.
Ê If required, connect the cables to the system board or other components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 117.
8.2 Upgrading a SAS/SATA RAID controller
I A SAS/SATA RAID controller is required for operating internal hard disk
drives. A SAS/SATA RAID controller is available for this purpose.
Ê Open the server as described in chapter "Preparation" on page 27.
To Next Page
Loading...
