38 Options Guide RX300 S6
Main memory
5.2 Expanding the main memory
Ê Open the server as described in chapter "Preparation" on page 27.
Ê Remove the air duct over the main memory (see "Removing the air duct" on
page 30).
Figure 10: Removing a memory module
Ê Press the securing clips on both sides of the memory slot concerned
outward (1).
Ê If the slot was equipped: pull the memory module out of the slot (2).
V CAUTION!
Please note the population rules in the Technical Manual for the system
board D2619-N.
Figure 11: Inserting a memory module
Ê Carefully press the memory module into the slot (1) until the securing clips
on both sides of it engage (2).
Pay attention to the plug coding.
/
/
0
/
0
0
To Next Page
Loading...
