122 Options Guide RX300 S6
Completion
10.5 Installing the server in the rack
I If you have not removed the server from the rack cabinet, please skip this
section:
Figure 102: Installing the server in the rack cabinet
V CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted.
V CAUTION!
At least two people are needed to position the server in the rack.
Ê Extend the interior telescopic rails completely to the front (1).
I They must click into place so that they can no longer be moved.
Ê Insert the prepared server into the protruding interior telescope rails (2) until
the rails engage.
Ê Release the locking mechanism of both rails - see (3a) for fully extending
rails and (3b) for partially extending rails.
Ê Push the server as far as it will go into the rack (4).
Ê Reconnect all the cables you disconnected beforehand and all new cables
on the rear of the server.
Ê Secure the server in the rack using the two knurled screws (5).
1
2
4
4
5
5
3a
3b
To Next Page
Loading...
