28 Options Guide RX300 S6
Preparation
4.1 Removing the server from the rack
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
button.
Ê Pull all power connectors out of the power outlets.
Figure 2: Knurled screws loosened and the server pulled out
Ê Loosen the two knurled screws (1) and pull the server as far as possible out
of the rack (2).
Ê Disconnect all cables on the rear side of the server.
I Depending on the accessibility of the server in the rack cabinet, it may be
helpful to remove the server from the rack cabinet. If you do not want to
remove the server from the rack cabinet, please skip the next step.
Release the locking mechanism of both rails - see (3a) for fully extending
rails and (3b) for partially extending rails.
Ê Lift the server off the rails.
V CAUTION!
At least two people are needed to lift the server out of the rack
cabinet.
1
2
2
3a
3b
1
To Next Page
Loading...
