14 Options Guide RX300 S6
Preface
1.3 Expansions and conversions
Main memory
The system board offers 18 slots for memory modules. 9 memory slots can be
used in mono processor configurations.
ECC with memory scrubbing and the Single Device Data Correction (SDDC)
function is standard.
There are three modes of operation for the main memory:
– Independent Channel Mode / Performance Mode (recommended)
– Mirrored Channel Mode
– Spare Channel Mode
Depending on the mode of operation there are different population
requirements.
Second processor
The system board can be upgraded with a second processor. Only processors
of the same type may be used on the system board. That means the number of
the internal processor cores as well as the primary clock and the FSB frequency
have to be the same. For dual operation, use a suitable multiprocessor
operating system.
Accessible drives
A number of mounting locations are available:
– one bay for a ServerView Local Service Panel (optional) or a ServerView
Local Service Display (optional)
– one bay for a slimline optical drive (option)
I The accessible drives integrated in these bays cannot be replaced during
operation.
In a 6x 3.5" or 8x 2.5" HDD configuration, a USB magnetic tape drive or a USB
RDX drive can be optionally installed in the right drive cage.
I In a 6x 3.5" HDD configuration, two bays are occupied in the drive cage.
These bays are no longer available for HDD modules.
The magnetic tape drive or the RDX drive cannot be replaced during
operation.
To Next Page
Loading...
