30 Options Guide RX300 S6
Preparation
4.3 Removing the air duct
I You only need to remove the air duct if you want to work in the area of
the expansion cards, main memory or processors.
Figure 4: Removing the air duct
I If you have installed an SAS/SATA RAID controller with a BBU: pay
attention to the BBU cable when lifting off the air duct! If you want to
remove the air duct from the server completely, first disconnect the BBU
cable from the controller.
Ê Take hold of the air duct by the green touch points, and lift it up and off.
To Next Page
Loading...
