RX300 S6 Options Guide 113
Further options
Figure 94: Securing a TPM Module
Ê Fasten the TPM with the special screw for the TPM.
Please use the TPM screwdriver insert bit to tighten the special screw.
I Do not fasten the screw too tightly (torque value of 0.6 Nm).
Ê Reinstall the air duct (see section "Inserting the air duct" on page 120).
Ê Insert the power supply cage as in section "Installing a power supply cage"
on page 118.
Ê Close the server (see section "Closing the server" on page 121), insert it into
the rack (see section "Installing the server in the rack" on page 122), connect
it to the power outlet, and switch it on, as described.
To Next Page
Loading...
