TX200 S6 Options Guide 55
Accessible drives and LSD/LSP
Figure 23: Removing EasyClick rails
Ê Detach the EasyClick rails from the dummy cover by removing the four
screws on each side.
I Note that there are two M3 x 4.5mm screws with M3 thread (yellow
ellipse) and two 6-32 x 4.8mm screws with UNC thread (blue ellipse)
on each side.
V CAUTION!
Keep the dummy cover for future use. If you remove the accessible
drive again and do not replace it with a new one, the dummy cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
Figure 24: Attaching the EasyClick rails - example: DVD drive
Ê Screw the EasyClick rails onto either side of the new 5.25-inch drive using
two M3x4.5mm screws.
Use the first hole in each lower row of holes as shown in the figure.
To Next Page
Loading...
