TX200 S6 Options Guide 85
Expansion cards and BBU
Ê Install a second RAID controller as described in the section "Installing
expansion cards" on page 73.
Ê Route the second BBU cable in the cable clamps.
Ê Connect the second BBU cable to the second controller.
V CAUTION!
The connector side with the three dots points towards you.
Ê Reinstall system fan 2 (or 2&4) as described in the section "Installing system
fan 2 (or 2&4)" on page 108.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 107.