108
[Add custom size] button
You can create up to 5 custom sizes.
Clicking the [Add custom size] button displays the following dialog box.
To add custom size documents
1) Click the [Add] button.
2) The following dialog box appears.
• When you select [Automatic Detection] in the "Output image size" drop-down list and
scan an irregular-sized document (not in the table above), the scanned image is output
in a standard size longer than and nearest to the original document size.
The next longer standard size may not be wide enough for your document. If the
document is clipped, or if you want to output a scanned document image in its original
size, create a custom document size beforehand in the "Add or Remove Custom sizes"
dialog box, and then select the custom size in the "Output image size" drop-down list.
The "Add or Remove Custom sizes" dialog box appears when the [Custom] button is
clicked.
• When you select [Automatic Detection] in the "Output image size" drop-down list, the
output image size may be larger than the original. If so, try the following:
- Insert a document into the Carrier Sheet so that the sides of the document and
Carrier Sheet becomes parallel.
- Adjust the side guides to the width of the Carrier Sheet to prevent the Carrier Sheet
from skewing.
If the situation does not improve, select a size in the "Output image size" drop-down list.
To Next Page
Loading...
