ScanSnap S510 Operator's Guide xv
Do not use any aerosol sprays or alcohol based sprays to clean
the scanner.
The following illustrates important cautions described in this manual.
Do not install the scanner on unstable surfaces.
Firmly insert the power plug.
Do not block the ventilation ports.
Do not place heavy objects or climb on top of the scanner.
Do not use any aerosol sprays or alcohol based sprays to clean the scanner.Dust
blown up by strong air from the spray may enter the inside of the scanner. This
may cause the scanner to fail or malfunction, or errors in scanned images.
Sparks, caused by static electricity, generated when blowing off dust and dirt from
the outside of the scanner may cause a fire.
Install the scanner on a flat, lever surface. Make sure none of the scanner parts
protrudes outside the desktop.
Do not install the scanner on unstable surfaces. Install the scanner on a level
surface that is free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner
and other devices.
Firmly insert the power plug into the power outlet as far it can go.
Do not block the ventilation ports. Blocking the ventilation ports generates heat
inside of scanner, which may results in fire or scanner failure.
Do not place heavy objects on the scanner or use the top surface of the scanner
for performing other work. Improper installation might cause injuries.
To Next Page
Loading...
Need help?
General
